Audi A2 e-tron uses upgraded APP350 drive unit with silicon carbide inverter
By Eve
Audi says the new A2 e-tron compact EV uses the Volkswagen Group's upgraded APP350 drive unit, a permanent-magnet synchronous motor running at 400 V with up to 350 Nm of torque, offered at 125, 140 and 170 kW. The inverter now uses silicon carbide MOSFETs in place of silicon-based bipolar transistors, with efficiencies of more than 97%, and the 140 kW version with the optional efficiency package has a preliminary combined WLTP consumption of 12.8 kWh/100 km, which Audi describes as the most efficient Audi ever. The report, published on 11 November 2026, also notes adaptive switching frequency software and rotor laminations more than 30% thinner than in the predecessor APP310.
Why it matters
A 400 V platform with a 12.8 kWh/100 km WLTP figure points to lower energy use per kilometre in mainstream compact EVs, which feeds into charging demand and dwell time assumptions for site planning. It also shows the Volkswagen Group staying with 400 V architecture for this segment, so procurement teams can keep planning for it in power and connector mix.
Source
- Original title
- “Audi’s new A2 e-tron uses an upgraded APP350 drive unit with a SiC inverter”
- Published
- 11 November 2026
- Updated
- 12 November 2026
In this story
- Topic
- Electric Vehicles
- Place
- Global
- Tag
- Audi
Related news
Electric Audi A4 delayed until 2029 as VW Group's SSP platform faces further setbacks
Audi has pushed back its electric A4 saloon, originally planned for production at Ingolstadt in 2028 as one of the first models on the Scalable Systems Platform (SSP), with Autocar understanding that production will not begin before 2029. The delay leaves Audi without a rival to the electric BMW i3, Mercedes-Benz C-Class and Tesla Model 3 in the mid-sized executive class. It follows Volkswagen's announcement that the electric Mk9 Golf on the same 800-volt platform had been delayed due to cost constraints.
Why it matters
A slower SSP rollout pushes back the arrival of a wave of 800-volt VW Group cars, which affects when demand for high-power charging from these models builds. CPOs and funders planning around the group's future vehicle mix should treat the 2028 timeline as less certain.
India's EV share of registrations reaches 8.5% in FY2025-26 as opinion piece urges retrofit-first approach for 33 crore combustion vehicles
An opinion piece reports that EV penetration in India reached 8.5% of total registrations in FY2025-26, up from 7.7% the year before, against a 30% target for 2030. It notes that more than 33 crore petrol and diesel vehicles remain on the road and that India had over 29,000 public charging stations as of December 2025, concentrated in a handful of states, with Karnataka cited. The article argues that Auto LPG retrofitment could offer a faster, cost-effective route to cutting emissions from the existing fleet.
Why it matters
The reported concentration of public charging in a few states and weak coverage in small towns points to uneven demand and siting opportunities for CPOs and tender bidders. The retrofit argument also signals that policy attention and funding may be contested between EV charging and alternative fuel approaches for the existing fleet.
Tata Motors Passenger Vehicles posts Rs 5,451 crore quarterly loss as JLR cuts margin guidance
In a weekly wrap of Indian automotive results for November 9 to 15, Tata Motors Passenger Vehicles reported a consolidated net loss of Rs 5,451 crore for the September quarter, after Rs 6,738 crore in exceptional charges, mainly at Jaguar Land Rover. JLR cut its full year margin guidance to 2 to 3 percent from 4 percent, while the India business posted record quarterly revenue of Rs 20,423 crore. The India business said it was absorbing around 60 percent of the rise in commodity costs and meeting only 60 to 65 percent of demand for its electric vehicles.
Why it matters
Tata's EV supply meeting only 60 to 65 percent of demand points to vehicle availability, not buyer appetite, as a constraint on EV uptake that charging demand depends on. Commodity cost pressure on manufacturers' margins is also worth watching when pricing and sourcing hardware and projects.
Tata Motors · Royal Enfield · BYD · Source